Respected Contributor.. Respected Contributor..
Respected Contributor..

NNMI 10.0 - Configure Analysis -> Performance pane?



Is it possible to configure what graphs to show in NNMi 10.0 Analysis -> Performance pane?


Customer would like to show a Custom Poller graph in that pane.



Thanks and regards, 



Lars-Erik Folcke


1 Reply
Acclaimed Contributor.
Acclaimed Contributor.

Hello Lars


Thanks for your question


Related to your comment, that is not possible to do it, if you want more detailed and complete information you should go to NPS.


There is not way to configure the Performance Tab for displaying information from a "Custom Poller"  rule.


The Analysis pane shows the performance graph in the Performance tab. Perhaps you could open a support case and request an Enhancement Request for your customer.


I hope this information helps you,



Vincent Montenegro Mena
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation.
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.