Highlighted
Frequent Contributor.. Frequent Contributor..
Frequent Contributor..
86 views

Reg.Node/Link/Interface status change

Hi Team

Is it possible to fullfill the below customer requirement in NNMi10.20 without any incidents.

=>Any link failure, link status to be highlighted in Red
=>Performance degradation (packet loss/high latency), then Node/interface  status to be highlighted in Amber
=>Bandwidth utilization above 50%, interface status to be highlighted in Yellow

Any one can help on this.

Regards

Mohan

0 Likes
1 Reply
Highlighted
Acclaimed Contributor.
Acclaimed Contributor.

Re: Reg.Node/Link/Interface status change

Hello Narkodu

Thanks for posting,

Unfortunately NNM does not have the capability to change the link color associated to an specific event. I think this can ve taken as enhancement request. You can go ahead an open a support case to start the ER proces.

Hope this helps,

Regards,

 

Vincent Montenegro Mena
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation.
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.