11.32 SP1- Issues fixed

[anoopambli]

I was going through the patch detail (SiteScope 11.32.361 Build Patch (11.32 IP1)) but it doesnt list anything about the issues fixed in this IP. Any idea?

https://softwaresupport.hpe.com/group/softwaresupport/search-result/-/facetsearch/document/KM02311893#Resolved Known Problems

[dirkf · Accepted solution]

Hi anoopambli,

sorry for the confusion and the bother.

I have requested that the patch description be corrected and this has now been finalized.

Changes done:

The patch description has now been fixed and is published to SSO.

We also now have the What’s New doc in the patch archive to be downloaded together with the bits.

The patch is now here (supersedes the initial ones for technical reasons beyond my knowledge):

https://softwaresupport.hpe.com/group/softwaresupport/search-result/-/facetsearch/document/LID/SIS_00394

https://softwaresupport.hpe.com/group/softwaresupport/search-result/-/facetsearch/document/LID/SIS_00393

And the change to the description is as follows:

Enhancements

Yes

SIS_00394:

Dynamic Docker Monitor Enhancements

New counters for all containers

New counters for running containers

Performance improvements

Please see What's New document included in the patch archive for full details

I hope this is satisfactory and hope you will excuse for the problems and bother.

Best regards,

Dirk

[anoopambli]

Thanks, that helps. Any details to the 'perofrmance improvement' part? Just wanted to check if it applies to our env.

[Disconnected]

I would like to know about the performance improvement as well.

[dirkf]

Hi Disconnected,

the above thread was about patch description, which has been changed accordingly. '

The full details (regarding additional monitors and improvements as well as the performance improvements) are discussed in detail in the What's New doc which is contained in the downloadable patch zip-archive.

does that help?

Best regards,

Dirk

[dirkf]

Ok, so seeing both of you asked the same info, here an excerpt of the guide stating the performance changes for your convenience:

• Performance improvements to allow monitoring of Docker containers at a higher frequency of one minute

(from the earlier 3 minutes).

• New parameter _dynamicDockerCheckContainersStatsThreadPullSize enables you to configure the

number of threads for the monitor run.

Best regards,

Dirk

[Disconnected]

Thank you!