Capturing the http response values and displaying it in reports.
there is a URL which sends out the below response.
success|456.323|page name|error info
is there a way to capture these 4 values and print it in a report.?
i also need to test the status each time the monitor runs ( to verify success or fail) and setup the alerts for this.
please let me know.
In URL monitors you can set thresholds using Content Match, in this case you need to use a regex such /(.*)/ then if that doesn't contain "success" then go to error state. About reports you can see the content matched only in the Errors/Goods/Warnings table at the end becase that's not a metric.
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
If you haven’t tried it yet, come and join us in our entitled forums at Support Customer Forums