Absent Member.. Absent Member..
Absent Member..

Sitescope 11.3 SAP JCo install and config

Product documentation isn't much clear on detailed steps to be followed to install and configure SAP JCo on Sitescope 11.3 servers. Expert do you have any experience and share it on this expert day to save few man hours to make Sitescope  easy tool to use for monitoring SAP systems?


Labels (2)
1 Reply
Micro Focus Expert
Micro Focus Expert

Hello ssawale,

Hope you are fine.


On the attached guide appear the specific procedure that  need to be follow to configure the SAP JCo. 

Please check the page:550 of the Monitor Reference ,Chapter 82: SAP CCMS Monitor.


That is the procedure that we always recomend to install the SAP Java Connector.


Hope this information can help you.

Best Regards,

Miguel Torres
Micro Focus SW Support

If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.

[Opinions expressed in my postings are mine alone, and do not reflect the opinions of my employer.No warranties express or implied for any solution/suggestion posted.]
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.