Highlighted
Super Contributor.. Super Contributor..
Super Contributor..
258 views

Maximum Sleep

Jump to solution

HPOO 10.6 - I have a use case that requires I sleep a flow for about 2 hours. I'm using the sleep operation to do this, but the flow result is Canceled - Timeout Expired when the sleep operation completes. Is there somewhere I need to make a configuration change to allow this?

0 Likes
1 Solution

Accepted Solutions
Highlighted
New Member.

Hello JamesLindsay,

 Thank you for contacting HPE Forum. 

 My name is Andrey, I am from the OO/CSA team. 

 Regarding your question, did you configured the global timeout setting? If not please do the following:

Configure the default timeout settings
1. Click the System Configuration Workspace button to display the System Configuration workspace.
2. Select System Settings > General.
3. In the Timeout (minutes) box, enter a number larger than 0, to set the number of minutes for the default
timeout setting. A flow run will be canceled if it exceeds this duration.
Note: This value must be an integer.
4. Click Save.

 

I hope this information helps you.

Best Regards,

 

Andrey Corrales Torres | SW Technical Support Consultant.
Operations Orchestration / Cloud Service Automation.
Hewlett Packard Enterprise

HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.

View solution in original post

1 Reply
Highlighted
New Member.

Hello JamesLindsay,

 Thank you for contacting HPE Forum. 

 My name is Andrey, I am from the OO/CSA team. 

 Regarding your question, did you configured the global timeout setting? If not please do the following:

Configure the default timeout settings
1. Click the System Configuration Workspace button to display the System Configuration workspace.
2. Select System Settings > General.
3. In the Timeout (minutes) box, enter a number larger than 0, to set the number of minutes for the default
timeout setting. A flow run will be canceled if it exceeds this duration.
Note: This value must be an integer.
4. Click Save.

 

I hope this information helps you.

Best Regards,

 

Andrey Corrales Torres | SW Technical Support Consultant.
Operations Orchestration / Cloud Service Automation.
Hewlett Packard Enterprise

HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.

View solution in original post

The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.