Absent Member.. Absent Member..
Absent Member..

[OO Tip] HF_169264 - Incorrect timeout Operations/Operating Systems/Windows/Remote Command Execution


When using OO: 9.05 (CP9) the timeout input in the "Operations/Operating Systems/Windows/Remote Command Execution" operation, the actual operation timeout is inconsistent with the value used.

Please look at the table below:

timeout (sec)  actual timeout
10                     25.641
30                     45.962
60                     73.086
300                  316.225
600                  619.419
3420 (57min)  3475.315

The differentiation between the timeout input value and the actual timeout should not be that much, if it cannot be precisely as the timeout value specified.


Please call HP OO Support and request this hotfix.

HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Labels (1)
0 Replies
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.