Frequent Contributor.. darrenj1 Frequent Contributor..
Frequent Contributor..
99 views

Timeout 1min 40 seconds

I have a timeout set in the flow properties of 100000, however sometimes when I run a flow or when a scheduled flow runs, it times out at 1min 40 seconds.

It seems to do this a few times, until i re enter the timeout value into the flow settings and run again.

Is there a known bug for this?

Labels (1)
0 Likes
1 Reply
Absent Member.. Pamela Harrod Absent Member..
Absent Member..

Re: Timeout 1min 40 seconds

Hello,

In order to troubleshoot this issue effectively, Technical Support will require additional information.  Please open a support case and including the following information:

- What version of OO are you running?  

- What specific operation are you using?

- What specific content pack is installed in this environment?  

- Do you see an error message?  If so, what is the specific error seen?

- What are the steps to reproduce the issue?

Thank you.

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.