Established Member.. AlekseyG
Established Member..

The "On field change" rule dependent on table component field

Hello! I have a Request Type Rule which populates the field with the total value from table component (on field change). All tests are OK and for most requests the rule works fine.

But in fact I've discovered that for some requests (i can't define what's special with them) the total of TC values differs from the result field value nevertheless the TC's values were changed after the rule was enabled.

What might be the reason? Aren't there any restrictions on using UI rules with table components?


Thanks in advance!

1 Reply
Natalia_R_PPM Absent Member.
Absent Member.

Re: The "On field change" rule dependent on table component field

Hello AlekseyG

I found some similar issues with users that explain that the Rules on table component doesn't work properly. Most of these issues are reported in old PPM versions (7.5 , 8.0 ,9.10 , 9.12 , 9.14)

1. Rules on table component when fields change not working properly

2. QCCR1L44587 9.12 table component dose not wokring


Also I found the following information

There will be errors with custom tokens

Token like REQUEST_TYPE_ID and WORKFLOW_ID should not be reserved in table component




Best Regards,
Natalia Rojas

HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.