DhillanK Absent Member.
Absent Member.

Code 31 on all NIC's after V2P using Platespin

Hi Guys

I need some assistance please. I did a V2P today from VMWare to a physical IBM server using PlateSpin Migrate.
Everything went well and the machine booted up on the hardware fine except for the Network interfaces. The OS (Server 2012 R2) identifies all the NIC's on the server however they are all in error state as follows:

The device is not working properly because Windows cannot load the drivers required for this device. (Code 31)

{Operation Failed}
The requested operation was unsuccessful.

I have removed vmware tools as part of the process, done driver updates, uninstalled and reinstalled the cards etc still no luck. I have worked for atleast 4-6 hours on this without making any headway. Luckily this is just a dev box and I allowed the downtime however i need to get this working so i can do the same for the Prod server.
Any assistance will be really appreciate.
1 Reply
AutomaticReply Absent Member.
Absent Member.

Re: Code 31 on all NIC's after V2P using Platespin


It appears that in the past few days you have not received a response to your
posting. That concerns us, and has triggered this automated reply.

These forums are peer-to-peer, best effort, volunteer run and that if your issue
is urgent or not getting a response, you might try one of the following options:

- Visit https://www.microfocus.com/support-and-services and search the knowledgebase and/or check
all the other self support options and support programs available.
- Open a service request: https://www.microfocus.com/support
- You could also try posting your message again. Make sure it is posted in the
correct newsgroup. (http://forums.microfocus.com)
- You might consider hiring a local partner to assist you.

Be sure to read the forum FAQ about what to expect in the way of responses:

Sometimes this automatic posting will alert someone that can respond.

If this is a reply to a duplicate posting or otherwise posted in error, please
ignore and accept our apologies and rest assured we will issue a stern reprimand
to our posting bot.

Good luck!

Your Micro Focus Forums Team

The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.