Established Member.. sandip_ALMAdmin
Established Member..
89 views

HP Tools Architecture Changes

Hi,

We are planning for the next upgrade for HP ALM and UFT from current version of ALM11.52 to ALM12.50 and UFT12.02 to UFT12.5x.

Understanding the architectural changes from current version to new version is really important to us, because during last upgrade from QC10 to ALM11.52 and UFT10 to UFT12.02 we faced lots of challenges.

Can you please share the details for the same?

Thanks,

Sandip

0 Likes
1 Reply
Highlighted
Absent Member.. Alonso_S_QC Absent Member..
Absent Member..

Re: HP Tools Architecture Changes

Hello Sandip,

Thank you for contacting us, i was wondering what are you referring by Architecture changes, what kind of information would you like? 

In this page you can find the support matrix for ALM with several HPE tools:

https://softwaresupport.hp.com/group/softwaresupport/search-result/-/facetsearch/document/KM01663677

Best Regards,

Alonso Sequeira Morales
SW Support Technical Consultant
San Jose, Costa Rica
hpe.com
Hewlett Packard Enterprise

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation”
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.