ozbrian Absent Member.
Absent Member.

Reflection V16 display question

Hi, I am moving from Reflection V7 to Reflection V16.

I am using V16 to connect to a Unix ERP system. The ERP system displays its menus in 80 columns.
Some reports print to screen but look like they change to 132 columns.

In V7 this was not an issue, Reflections would change from 80 to 132 and back again.
In V16 when I run a report to screen it dissapears - most likely it can't display in 80 columns.

How can I get V16 to display reports like V7 used to.

I cannot check my Reflection V7 settings as the program will not load anymore after a windows update. It complains about Visual Basic and shuts down.
I figure it is probably time to update as V7 must be pretty old by now.

1 Reply
TomFitz Absent Member.
Absent Member.

Re: Reflection V16 display question

Hi Brian,

we would really need to see a Reflection trace of the data stream to figure out what escape sequences the host is sending us, and then configure your session to accommodate it. Can you open a ticket with Technical Support (Support2@microfocus.com)?

The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.