Highlighted
RaphAlv Respected Contributor.
Respected Contributor.
207 views

No Tests Defined Patch Scan

Hi community
After a scan for patch compliance the result is "No Tests Defined". 
The SA_10_51_User_Guide.pdf for the compliance checks won't give any status like this...
scanresults01.JPG

0 Likes
2 Replies
Micro Focus Frequent Contributor
Micro Focus Frequent Contributor

Re: No Tests Defined Patch Scan

Hello RaphAlv,

 

Is possible that there is no patch policy attached to that target server so if you make a scan to this target it will display that message cuase there is no patchpolicy to scan to check if it is compliant or not.

You can go to the managed server where you are trying to run the scan, rigth click >> open, then go to Management Policies >> Patch Policies and please check if the server has patch policies attached to it.

If not then please proceed to add the patch polocy you need and after this please attempt to run the scan one more time.

Best Regards,

Juan Diego Barrantes
Customer Support Engineer

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation.
0 Likes
RaphAlv Respected Contributor.
Respected Contributor.

Re: No Tests Defined Patch Scan


@Juan_B_SA wrote:

Hello RaphAlv,

 

Is possible that there is no patch policy attached to that target server so if you make a scan to this target it will display that message cuase there is no patchpolicy to scan to check if it is compliant or not.

You can go to the managed server where you are trying to run the scan, rigth click >> open, then go to Management Policies >> Patch Policies and please check if the server has patch policies attached to it.

If not then please proceed to add the patch polocy you need and after this please attempt to run the scan one more time.

Best Regards,


That use to have policy attached. Sysadm solve by agent reinstallation...
Thanks

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.