SM9.34.4001 - incorrect sysmodtime/sysmoduser in CHM/CHT Modules if 'Save & Exit' is used
The date.entered and operator fields should get updated when a the change or change task us updated but this is not occurring if the 'Save & Exit' button is used and because these fields are not updated there is no update to the record in the cm3r/cm3t table so the sysmod fields are not updated either. the only thing that is working is that the activity record is created and this make for as descepancy between the last activity update and the sysmodtime/sysmoduser data.
If the 'Save' Button is used everything is updated as expected.
Does this occur in anyone elses systems?
As SM design,
- sysmodtime field is updated if 'Save'/'Save & Exit' button are used.
however, this field is not updated if you just click 'Save'/'Save & Exit' button without any change of field.
Could you check whether you changed any field when clicking 'Save & Exit' ?
Thank you for using the HPE Community. If you find that this or any post resolves your issue, please be sure to mark it as an "accept as solution".
I have reproduced your issue.
A possible solution is to modify the cm.ok Process record.
In the Process record add this expression at the end of the Evaluated Expression before RAD call field for the RAD cm.update.save.
if ($L.continue and $L.mode="update") then ($L.do.cm.update=true)
If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation.