Highlighted
Absent Member.. AWHITE Absent Member..
Absent Member..
146 views

Support tip: incorrect info in Process Designer release notes

Hello,

 

Unless you have not caught this already, which may be the case since the info is awaiting a future release of PD, but some documentation from Process Designer provided some incorrect info.

 

From the ProcessDesignerCP9.30.2_ReleaseNotes.pdf:

On page 13 of the release notes, it says:

"Increase the size of field defaultTemplate in table changeModels from 80 to 400."

There is no table called "changeModels". There is a table called "changeModel", but it does not have a field called "defaultTemplate". There IS a field called "changeTemplate".   Please confirm table is changeModel and field is changeTemplate.

R&D confirmed this was incorrect:

 

1. In the following sentence:
    Increase the size of field defaultTemplate in table changeModels from 80 to 400.
    The defaultTemplate should be changeTemplate, and changeModels should be changeModel.


2. In the instructions for modifying the operator table, there are no steps to change the "Text" data type to the "varchar" data type.

 

See QCCR1E91269

 

Regards,

 

Andrew

 

“HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.”
Labels (1)
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.