AMVolynsky
New Member.
74 views

clean multiselect

I placed in ds (display screen) of problem calculation containing "multiselect.selection("rows")". It's working right.
But when i open other problem which not need this calculations i receive old values.
How can i clean "multiselect.selection("rows")" after my calculations?

0 Likes
1 Reply
Jhonny_C_SM Frequent Contributor.
Frequent Contributor.

Re: clean multiselect

Greetings.

I would suggest to establish a condition in the same Calculation in order to specify which Problems you want that calculation to be applied to, maybe a condition with the Category of the Problem, the thing is that you need to evaluate or separate the Problems that need the calculation.

I hope this works for you.

Regards,

Jhonny Castro Montero
SW Support Technical Consultant
San Jose, Costa Rica
hpe.com
Hewlett Packard Enterprise

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.