Highlighted
fabian310580 Contributor.
Contributor.
234 views

error when i want to create a change.

Jump to solution

Hi community!!!!

Please i need your help. I have this error when i want to create a change.

file:(SYSATTACHMENTS) key:(application=cm3r,topic=,type=5,segment=0,uid=5853ecce0011e08e80b07a98) (format.ccal,calc.calculations)

Tks. i wait yours coments

0 Likes
1 Solution

Accepted Solutions
TomPowe Acclaimed Contributor.
Acclaimed Contributor.

Re: error when i want to create a change.

Jump to solution

When you create the Change, is it always the exact same error and the exact same UID?

uid=5853ecce0011e08e80b07a98

If so, look through your SYSATTACHMENT table in the database and see if you can locate the record.  If you can, it seems like it has no value in the TOPIC field.  Topic in this case would be a valid change number, however, since it's blank, it seems like the data is corrupt. You might want to just delete the record and see if the error goes away.

0 Likes
5 Replies
Outstanding Contributor.. Ngoc_Ngo_SM Outstanding Contributor..
Outstanding Contributor..

Re: error when i want to create a change.

Jump to solution

Dear Fabian,

 

Would you please help to write the steps that you have done and you meet the error?

Also, please replicate the issue and upload the log file for we can do a further check on it.

Thank you and best regards,

If you find that this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the post and show your appreciation.
0 Likes
TomPowe Acclaimed Contributor.
Acclaimed Contributor.

Re: error when i want to create a change.

Jump to solution

Search in your "cm3r" format control, in Calculations, for any lines that mentions SYSATTACHMENTS. 

0 Likes
Honored Contributor.. Josh_MM Honored Contributor..
Honored Contributor..

Re: error when i want to create a change.

Jump to solution

Can you also post the entire error message? The location where the issue comes up is, as pointed out before, in FormatCtrl. The reason for it (and therefore the place to fix it) might however not be there.

0 Likes
fabian310580 Contributor.
Contributor.

Re: error when i want to create a change.

Jump to solution

Hi Tks.

But I have reviewed that you say and I do not have any line where it is  "SYSATTACHMENTS"

0 Likes
TomPowe Acclaimed Contributor.
Acclaimed Contributor.

Re: error when i want to create a change.

Jump to solution

When you create the Change, is it always the exact same error and the exact same UID?

uid=5853ecce0011e08e80b07a98

If so, look through your SYSATTACHMENT table in the database and see if you can locate the record.  If you can, it seems like it has no value in the TOPIC field.  Topic in this case would be a valid change number, however, since it's blank, it seems like the data is corrupt. You might want to just delete the record and see if the error goes away.

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.