Absent Member.
Absent Member.
1561 views

Cannot get current build & version in setup case

Hi,

Currently we plan to use setup case to deploy our test target once and run all the test cases when deployment is success. However, in setup case, the build & version in environment variable is always the same value. It does not change to the build & version we currently run. For example, there are two version A & B. The setup case always gets version A in environment variable, even if the execution is triggered in version B. In this circumstance, we cannot use setup case to deploy test target because the version is wrong.

We wonder if it is possible to get the current build & version in setup case so that we can deploy the correctly target?

ps. The SilkCentral version is 2010R2.

Regards,
ChangZhuo

0 Likes
2 Replies
Micro Focus Expert
Micro Focus Expert

Hi ChangZhuo,

Thanks for your question, I have looked into this and it will require further input from our development team. Therefore in order to faciltate this please open a support incident via the SupportLine website here.

Thanks

Michael

0 Likes
Absent Member.
Absent Member.

Hi Michael,

The incident #2600963 is create for the case. Please help to check it, thanks.

Regards,

ChangZhuo

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.