Having problems with your account or logging in?
A lot of changes are happening in the community right now. Some may affect you. READ MORE HERE

Is it possible to modify the severity of SYSTEM errors using the ErrorAdd function?

Is it possible to modify the severity of SYSTEM errors using the ErrorAdd function?

Some errors that were previously reported as Winsock errors are now reported as System errors, for example:

WinSock: 10061 - Connection refused, host="YourHost:80", attempts=3

is now reported as

SYSTEM: 10061 - No connection could be made because the target machine actively refused it.

To modify the severity using the ErrorAdd function in previous versions would have meant using this format:

ErrorAdd(FACILITY_WINSOCK, 10061, SEVERITY_INFORMATIONAL);

However as 10061 errors can now be reported as a SYSTEM errors and there is no parameter for FACILITY_SYSTEM listed in the Help use following format instead

ErrorAdd(NULL, 10061, SEVERITY_TRANS_EXIT);

i.e. replace the FACILITY parameter with NULL

DISCLAIMER:

Some content on Community Tips & Information pages is not officially supported by Micro Focus. Please refer to our Terms of Use for more detail.
Top Contributors
Version history
Revision #:
1 of 1
Last update:
‎2013-02-15 19:02
Updated by:
 
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.