kkyy Super Contributor.
Super Contributor.
463 views

Changes not reflected after adjust the workload

Hi all,

We just upgraded from Silk Performer 17.0 to Silk Performer 18.5.

We are trying to run a project with SP 18.5.  In the Silk Performer Wokrkbench, we click the Adjust Workload, and we choose the All Day workload model, then we change the max vUsers and simulation time etc.  Then we click the Run Test,  the Workflow-Workload Configuration appears, but we still see that the Max Vusers showing the old value instead of the new value that we just changed.

The same project works fine in 17.0.  Also, in 17.0, when we click the Adjust Workload and make some changes, there is this message appears "The All Day Workload Configuration model has already been configured.  Do you want overwrite the existing model with the changes you have made?"

However, the same pop up message doesn't displayed in 18.5.

 

Thank you for any pointers!

0 Likes
1 Reply
Danny Davey Absent Member.
Absent Member.

RE: Changes not reflected after adjust the workload

This was confirmed as a defect, through a support case, which will be addressed in a future update.
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.