Micro Focus Expert
Micro Focus Expert
138 views

OA Support Tip: Changing Agent default ports on OMW

Operations Manager for Windows allow you to change to listening port of the agents, following is a tip on how to enable this option successfully.

 

 

On OM server:

The server will not look for different ports on regular groups, hence it is recommended that you create a group that will contain all the nodes that will be using an specific port.

The agent or agents listening on specific ports need to be grouped by IP addresses, FQDNs, host-names and then the management server needs to be configured so that when it needs to communicate with the agents listening on non-default ports it will know which port to use.

The example below configures the management server to communicate with all agents on port 2000 where the FQDN of the agent ends in hp.com.

ovconfchg -ns bbc.cb.ports -set PORTS *.hp.com:2000

 

 

On the agent:

To change the agent to listen on a new port use the following command:

ovconfchg -ns bbc.cb -set SERVER_PORT 2000

 

 

For more information consult the firewall documentation which can be found on the documentation portal KM829492.

HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Tags (2)
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.