Highlighted
Absent Member.. Absent Member..
Absent Member..
173 views

Checkpoint and Parameters for BPT

Jump to solution

Hi,

 

I have a requirement to verify the Oracle buttons position within a windows application using checkpoints in UFT 11.53

 

Please let me know how can we verify the positions.

 

Also in addition to it please let me know how to pass input and output parameters between two components in BPT.

 

 

Application - Oracle forms 10g

Tool - UFT 11.53

 

Thanks,

Murali

0 Likes
1 Solution

Accepted Solutions
Highlighted
Outstanding Contributor.
Outstanding Contributor.

Re: Checkpoint and Parameters for BPT

Jump to solution

Hi Murali,

 

Hope you are doing well.

 

I recomend to use the Low Level Record, please refer the below document:

 

https://softwaresupport.hp.com/group/softwaresupport/search-result/-/facetsearch/document/KM00204409

 

Best regards.

 

Ruddy Alvarez H.
Customer Support Engineer

If you find thst aat this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the pond show your appreciation.

View solution in original post

0 Likes
3 Replies
Highlighted
Absent Member.
Absent Member.

Re: Checkpoint and Parameters for BPT

Jump to solution

Hi,

 

Is your buttons created by images? if so, you can use bitmap checkpoint to verify it.

About how to pass param between 2 components in BPT, I tried to do a research about it and found out that this can be done using input and output parameters and that output is captured using standard output check point.

 

Thank you

"HP Support
If you find this or or any post resolves your issue, please be sure to mark it as an accepted solution and give KUDOS to the author for their assistance."
0 Likes
Highlighted
Absent Member.. Absent Member..
Absent Member..

Re: Checkpoint and Parameters for BPT

Jump to solution

Hi,

 

Thanks for your reply.

 

I was able to do the passing of parameters.

 

But regarding the Oracle buttons, thay are not images and all buttons are displayed as Oracle buttons.

 

In this case how can we proceed to identify the button position within the Oracle windows application.

 

 

Thanks,

Murali

0 Likes
Highlighted
Outstanding Contributor.
Outstanding Contributor.

Re: Checkpoint and Parameters for BPT

Jump to solution

Hi Murali,

 

Hope you are doing well.

 

I recomend to use the Low Level Record, please refer the below document:

 

https://softwaresupport.hp.com/group/softwaresupport/search-result/-/facetsearch/document/KM00204409

 

Best regards.

 

Ruddy Alvarez H.
Customer Support Engineer

If you find thst aat this or any other post resolves your issue, please be sure to mark it as an accepted solution.
If you are satisfied with anyone’s response please remember to give them a KUDOS by clicking on the STAR at the bottom left of the pond show your appreciation.

View solution in original post

0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.