Highlighted
Absent Member.
Absent Member.
1269 views

iPrint for Remote Office

I was just informed that my organization is opening a remote office on the other side of the state and I need to come up with ways to support that office, and printing is one of those ways. Is there a way with iPrint to be able to set up the ability to print to any printers that I will be setting up at the new office?

Not to vent too much about the situation, but it is one of those examples where the decision was made without asking IT what we would need to do to pull this off and at this time all that I know that I have is Internet bandwidth at the hosting location. I know that with iPrint today I can install a printer which is back at my organization's office and someone can print from anywhere that has an Internet connection. What I would like to be able to do is keep using iPrint for whatever printer that I will end up having to install at this satellite office so that while they are there (or someone needs to print to it that is heading there) that it works the same way as iPrint here at the office and still have the audit controls that I have with iPrint.

What are my options to try to make this happen? I can think of either using an IPSEC tunnel, but I don't know what my options will be at the new location, or to set up a second iPrint appliance with a second print domain for that satellite office. Thanks!
0 Likes
1 Reply
Highlighted
Absent Member.
Absent Member.

Re: iPrint for Remote Office

marklar23,

It appears that in the past few days you have not received a response to your
posting. That concerns us, and has triggered this automated reply.

These forums are peer-to-peer, best effort, volunteer run and that if your issue
is urgent or not getting a response, you might try one of the following options:

- Visit https://www.microfocus.com/support-and-services and search the knowledgebase and/or check
all the other self support options and support programs available.
- Open a service request: https://www.microfocus.com/support
- You could also try posting your message again. Make sure it is posted in the
correct newsgroup. (http://forums.microfocus.com)
- You might consider hiring a local partner to assist you.
https://www.partnernetprogram.com/partnerfinder/find.html

Be sure to read the forum FAQ about what to expect in the way of responses:
http://forums.microfocus.com/faq.php

Sometimes this automatic posting will alert someone that can respond.

If this is a reply to a duplicate posting or otherwise posted in error, please
ignore and accept our apologies and rest assured we will issue a stern reprimand
to our posting bot.

Good luck!

Your Micro Focus Forums Team
http://forums.microfocus.com



0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.