Highlighted
Absent Member.
Absent Member.
761 views

vmxnet3 instead of e1000 ethernet controller for virtual app

Is it possible to change the e1000 board in the iprint appliance 2.1 to the vmxnet3 board? If yes, exist there a instructions manual. I didn't found anything.
Our vmware service provider is not amused about the e1000.


Thanks,

Hagen
0 Likes
2 Replies
Highlighted
Knowledge Partner
Knowledge Partner

Re: vmxnet3 instead of e1000 ethernet controller for virtual app

On 23/11/16 15:56, HagenFreySPDTHL wrote:

> Is it possible to change the e1000 board in the iprint appliance 2.1 to
> the vmxnet3 board? If yes, exist there a instructions manual. I didn't
> found anything.
> Our vmware service provider is not amused about the e1000.


Yes it's possible - please see
https://www.novell.com/documentation/iprint-appliance-2/iprint_admin/data/network.html

HTH.
--
Simon
Micro Focus Knowledge Partner

------------------------------------------------------------------------
If you find this post helpful and are logged into the web interface,
please show your appreciation and click on the star below. Thanks.
------------------------------------------------------------------------
0 Likes
Highlighted
Absent Member.
Absent Member.

Re: vmxnet3 instead of e1000 ethernet controller for virtual

Ok, it should work with a second board. I will test it. Thank you

Hagen
0 Likes
The opinions expressed above are the personal opinions of the authors, not of Micro Focus. By using this site, you accept the Terms of Use and Rules of Participation. Certain versions of content ("Material") accessible here may contain branding from Hewlett-Packard Company (now HP Inc.) and Hewlett Packard Enterprise Company. As of September 1, 2017, the Material is now offered by Micro Focus, a separately owned and operated company. Any reference to the HP and Hewlett Packard Enterprise/HPE marks is historical in nature, and the HP and Hewlett Packard Enterprise/HPE marks are the property of their respective owners.